Skip to main content

Saving, precise and clean

THE TASK

CLEAN EDGES WITH MINIMAL MATERIAL WASTE

Edges of material webs must be trimmed cleanly. In conventional cutting processes, disturbing heat often develops due to the friction between the knife and the material. This heat has a particularly negative effect on thermoplastic fibers. This is because these fibers melt on the cutting edge, so that it often has to be cleaned and reground. Blunt knives cause the edges to become uneven.

An optimal cutting process is characterized by an exact cut, minimal material waste, low heat generation and long blade life.

Minimize edge waste with the WEKO-Cut-it.

Slow rotating cutting discs minimize heat energy caused by friction.

The WEKO-Cut-it features optimum pressure and special grinding, significantly increases the service life of the cutting discs. The cutting head can be adjusted to cut on the pinholes, minimizing material waste. The WEKO-Cut-it can be easily integrated into lines, even as a retrofit, and ensures maximum productivity and profitability.

  • Operate with AC motors
  • Cut width adjustment with step motor and edge sensor.
  • For all types of stenter frames
  • Control of edge drop without operator intervention
  • Minimum trim waste
  • Cut-off material is reliably removed
  • Cutting discs with maximum service life
  • Sensors with display for optimum trim setting

Contact

Benjamin Ziel

General Manager WEKO América Latina +55 (0) 47 3333 1320
info@weko.net.br